15 May
15May

Did you know that most of the people consider hiring a professional for painting the exterior side of their house just to make sure that their project is completed in the best possible way? Well, DIY painting projects also turn out to be great if you have the right tools and have the skills.

Keep in mind that a good paint job will last more than 10 years. The only things that you need to keep into consideration are the ones that we’ve mentioned below! Yes, we’ve compiled a list of few steps that you need to take in order to ensure that the exterior paint looks good. There will be no need of hiring a professional for their exterior painting service Norcross GA.

Step #1: Getting The Lead Out

A DIY fanatic is not obligated to follow that EPA regulation as the professional and licensed painting contractors must. However, if you house was built in 1970s, when lead paint was banned for painting, you should be careful in getting airborne lead particles.

Step #2: Wash The Exterior 

You should know that mildew and mold thrive under fresh paint. Mold and mildew will not allow the paint to adhere to the surface of the wall. So, it is highly recommended that you wash the exterior side of the house properly.

Step #3: Scrape Off Loose Paint

When it comes to outside painting in Norcross GA, you need to first scrape loose paint from the walls. You need to use a handheld scrape for the job.

Remember that you should not use an open flame torch as it can start a fire.

Step #4: Fill And Repair

After you’ve washed and sanded the walls of the house. You need to step back and inspect if they’re any holes, dings, or chips. You need to carefully fill all the minor and major holes and also apply major putty or a compound.

If you’ve got a major rot problem, you need to hire a professional carpenter to replace the bad wood and then a team of painters in Norcross GA to paint it back to its original self.

Step #5: Sand The Rough Spots 

Have you be looking at the walls that have some rough spots? If yes, then you need to sand them until they get smooth. Take care not to push so hard or you will end up leaving sander marks in the wood.

Comments
* The email will not be published on the website.
I BUILT MY SITE FOR FREE USING